BARIX Instreamer Instrukcja Użytkownika Pobierz pdf (Strona 11)

Barix Instreamer User Manual Version 01.03

Page 9

7.4 Streaming settings

These settings adjust the streaming mode, parameters and

destinations.

Own Name

You can enter the name of the Barix Instreamer here. This

name will be returned when using the DISCOVER

command (see technical documentation) and will be used

for the SYNC function in the Barix Exstreamer (see Barix

Exstreamer User Manual).

Streaming mode

"send always"

will stream always

"send on CTS"

will stream if the SEND button (command)

is pressed or CTS (Pin 8 Serial connector) is connected to

a positive supply (9VDC, Pin 4 Serial connector)

"send on Level"

will stream if the incoming audio signal is

above the Trigger level

Trigger level

Is only used when Streaming mode is

"on Level"

Set to a value between 0 and 32767.

Open the Device status page and look for the Input peak

value to get a hint for the trigger value. This page refreshes

itself every few seconds.

Pre Trigger Start

Pre Trigger Start can be adjusted to prevent cut offs when

audio should be sent earlier than detected. It defines the

amount of time that will be streamed before the actual

trigger occurred. This feature is most likely used in

combination with the send on level feature.

Post Trigger Play

Post Trigger Play can be adjusted to prevent cut offs when

audio should be sent longer than detected. It defines the

amount of time that the device will continue streaming

after the actual trigger has been cleared. This feature is

most likey used with the send on level feature.

Buffer Underrun Mode (TCP)

The Buffer Underrun Mode (TCP) defines the action if a

TCP stream is slower than the real stream from the

encoder. In this case the output streaming buffer underruns

and cannot hold older data anymore. The device can then

"disconnect"

the TCP connection or it can

"skip"

the

stream directly to the encoder stream without

disconnecting TCP.

Streaming Strategy

The Streaming Strategy defines how a packet is build and

sent. On

"lowest latency"

the encoded data will be sent

directly after the encoding. On

"optimal package"

the

packet will be filled up before sending.

UDP Tx Source Port

This setting is only used with a custom software

application. Enter the used source port number for a UDP

stream (between 0 and 65535). When set to 0 the source

port is set to the same port as selected in the destination

port (in section Stream to). If destination is set to

"origin

source"

the UDP Receiver Port is used.

Sync Port

This parameter should only be changed if you use a firewall

and. Enter the used port number for the sync stream

(between 0 and 65535). When set to 0 the port is

calculated by an algorithm.

Radio Path

Enter a radio path to listen to the transmitted stream of

this Barix Instreamer using a device that is able to play MP3

radio stations (also PC software like WinAmp).

The URL to connect is http://x.x.x.x/p. Where x.x.x.x is

the IP address of this device and /p is this Radio path.

Example: http://192.168.0.24/xstream

The device can serve up to 6 radio streams.

Stream to

There are up to 8 destinations to stream to. Each one can

be directed to a device, or a multi- or broadcast address.

Conn. type

Choose the type of connection:

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 22 23

Komentarze do niniejszej Instrukcji

Brak uwag

BARIX Instreamer Instrukcja Użytkownika Strona 11

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking BARIX Instreamer